Department of Mechanical Engineering
Kenneth E. Goodson
King, W.P., and Goodson, K.E., 2007, "Thermomechanical Formation of Nanoscale Polymer Indents using a Heated Silicon Tip," ASME Journal of Heat Transfer, Vol. 129, pp. 1600-1604.
In thermomechanical data storage, a heated atomic force microscope cantilever tip is in contact with and scans over a polymer film. Heating in the cantilever and cantilever tip induces local deformation of the polymer near the tip, with indents as small as 22 nm. This paper reports a simple modeling approach for predicting heat and mass transfer in the cantilever tip and polymer with the goal of predicting indent formation conditions. The model accounts for subcontinuum conduction in the cantilever tip and for the time- and temperature-dependent mechanical properties of the polymer. Simulations predict steady state and transient indent formation, and the results compare well with data. For loading forces 30–200 nN and a tip radius of 20 nm, a cantilever temperature of 200°C is required to form an indent at steady state. For heating pulses as short as 5 microseconds, the cantilever temperature required for bit formation is as high as 500°C. By quantifying the conditions required for indent formation, this work may improve the operation of heated probes for thermomechanical data storage.